Select the line with the Select tool, then erase it.Select the Pencil tool and draw a line across the bottom of the dome.Select the Eraser tool and erase the edge of the first circle.Select the Follow Me tool, and click on the face of the second circle.Select the Select tool and click on the first circle.Select the Eraser tool and erase the lower half of the second circle.Draw a line on the under side of the two circles.Select the Pencil tool and click on the first circle.To draw some interesting sphere shaped polyhedra, just set the edge properties to Visible, and enter a small number for the latitude and longitude lines. CTRL+click on the component and select explode.You can also control the edge properties so that they are Smooth, Soft, or Visible. The more lines, the more smooth the surface will be. You can specify the number of latitude lines and longitude lines to control the amount of geometry created.
Enter the parameters in the dialog box, and click OK.CTRL + click again and select Close group Finally, you can make your own meshes using a 3D modeler such as Blender or Sketchup. You might find that your faces are flipped.ĬTRL+ click on the group and select Edit Group. Gazebo provides a set of simple shapes: box, sphere, and cylinder.This will open a dialog box to enter the sphere parameter values.
Sketchup make a sphere install#
Sketchup make a sphere full#
That circle should be entirely erased, leaving the full sphere. Use the Erase tool to erase the edge of the first, larger, circle.Select the Follow Me tool, and then click the face of the second, smaller circle.Select the Select tool and click on the first circle.Then use the Select tool to select the face of the first, larger circle. With the inference direction locked, draw a second circle inside the first, but make it a little smaller than the first.With the Circle tool still selected, move your cursor along the top edge of the drawing until the circle cursor turns red or green, and then press and hold the Shift key to lock that inference direction (both of these inference directions are perpendicular to the ground plane). Hand drafting for Interior Design, SketchUp, Autodesk 123D and MakerBot. Start your circle at the origin point (the point where the red, green, and blue axes intersect). Select the Circle tool to draw a circle on the ground plane.If you don't have SketchUp installed, download it from and install it. Install the extension as described in the right column - restart Sketchup and open this tool from the Sketchup Plugins menu.
0 kommentar(er)
